User's Manual
Table Of Contents
- FCC Part 15
- Unauthorized Changes to Equipment
- FCC RF Exposure Limits
- Antenna Installation
- Compliance with FCC deployment rule regarding the radiation of noise
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Installation
- 4 BSF-4004 Commissioning
- 5 BSF-4004 Full GUI Description
- 6 Monitoring, Fault Sourcing and Maintenance
- Appendix A - Specifications
- Appendix B - F/O Cleaning Procedure
AXELL BSF-4004 BSF0038 SERIES REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
5.4 Remote Communication Setup
This section describes the Ethernet and modem setup. The SNMP setup option also
available in this dialog is described in section
5.5. SNMP .
Select an option (ETH TCP, Modem or SNMP) and configure. Then select the next relevant option.
NOTE: The configuration of each option is saved and active. It is not relevant which option is
currently selected (ETH TCP, Modem or SNMP).
5.4.1 TCP/IP and Ethernet
1. Click on the Config button.
2. From Device:Method select ETH:TCP (Ethernet:TCP/IP).
3. Click Apply.
Figure 5-9: Remote ETH Configuration
© Axell Wireless Ltd Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0 35