User's Manual
Table Of Contents
- FCC Part 15
- Unauthorized Changes to Equipment
- FCC RF Exposure Limits
- Antenna Installation
- Compliance with FCC deployment rule regarding the radiation of noise
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Installation
- 4 BSF-4004 Commissioning
- 5 BSF-4004 Full GUI Description
- 6 Monitoring, Fault Sourcing and Maintenance
- Appendix A - Specifications
- Appendix B - F/O Cleaning Procedure
AXELL BSF-4004 BSF0038 SERIES REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Figure 4-5: Example of Partial view of BSF-3604 Configuration window
3. In the Downlink section:
• Verify the Amplifier is set to ON.
• Set Attenuation to maximum value (15dB).
• Lower the Attenuation level step by step until the desired Output power level is reached
(Zero attenuation = maximum gain).
• Verify the Amplifier Saturation is GREEN.
Figure 4-6: BSF-4004 Downlink Configuration Section
UL Attenuation
DL Attenuation
UL/DL bandwidth
Saturation
status
© Axell Wireless Ltd Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0 23