User's Manual

Table Of Contents

AXELL BSF-4004 BSF0038 SERIES REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

3.7.3 Power ON

3.7.3.1 Switching Power ON

Caution!!

Make sure the antenna cables or 50Ω terminations are connected to the repeater’s antenna connectors

before the repeater is turned on.

1. Switch on the Main Power Switch.

2. Switch on the Battery power.

Figure 3-20: BSF-3604 Power Module

Note: The power switches have two positions: “on” and “stand by”. In the stand by position the

repeater is still connected to the power supply but not operational.

3.7.3.2 Verifying LEDs

Verify the LEDs from the following modules are indicating correct operation (see section 6.4):

• Control module

• F/O converter

• Power supply modules

3.8 Closing and Securing the Repeater

Close lid, tighten the screws and lock repeater. Continue with the following section to setup the

repeater.

Note: The two screws must be fully tightened. Failure to do so may affect the IP65 compliancy and

therefore any warranty.

Main Power

Switch

Battery

Switch