User's Manual
Table Of Contents
- FCC Part 15
- Unauthorized Changes to Equipment
- FCC RF Exposure Limits
- Antenna Installation
- Compliance with FCC deployment rule regarding the radiation of noise
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Installation
- 4 BSF-4004 Commissioning
- 5 BSF-4004 Full GUI Description
- 6 Monitoring, Fault Sourcing and Maintenance
- Appendix A - Specifications
- Appendix B - F/O Cleaning Procedure
AXELL BSF-4004 BSF0038 SERIES REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
4. Connect the fibre to the Fibre Optic Converter inside the repeater.
Note: Make sure the fibre is not bent too sharply inside the repeater as to avoid communication
disruptions.
5. Place the fibre in the rubber seal.
Note: The sleeve (not supplied), together with the rubber seal, meets the protection standard IP65.
6. Adjust the fibre length inside the repeater and insert the seal into the fibre input interface.
© Axell Wireless Ltd Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0 11