User's Manual
Table Of Contents
- FCC Part 15
- Unauthorized Changes to Equipment
- FCC RF Exposure Limits
- Antenna Installation
- Compliance with FCC deployment rule regarding the radiation of noise
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Installation
- 4 BSF-4004 Commissioning
- 5 BSF-4004 Full GUI Description
- 6 Monitoring, Fault Sourcing and Maintenance
- Appendix A - Specifications
- Appendix B - F/O Cleaning Procedure
AXELL BSF-4004 BSF0038 SERIES REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
1.5.3 Internal Interfaces
This section shows the internal interfaces for the repeater. You will need to open the Repeater in
order to do the following:
• Connect power
• Connect optic fibres
• Connect alarms (if relevant)
• Power-on (Power-ON and Battery ON switches)
• Optional – USB/Ethernet port for local setup
Figure 1-3: Single Band Repeater with Door Open
Alarms and relay connections.
Refer to section 2.6 for
descriptions
F/O Converter LEDs and optic
connector to which routed optic
fiber is connected (section 2.5)
Power connections
(section 2.7)
Controller module – USB/Ethernet
local setup connections. Refer to
section
6.3.1 for LED descriptions
Rechargeable backup
battery pack, see 2.7.6
Power and battery switches
See section 2.7
6 Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0 © Axell Wireless Ltd