User's Manual
Table Of Contents
- FCC Part 15
- Unauthorized Changes to Equipment
- FCC RF Exposure Limits
- Antenna Installation
- Compliance with FCC deployment rule regarding the radiation of noise
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Installation
- 4 BSF-4004 Commissioning
- 5 BSF-4004 Full GUI Description
- 6 Monitoring, Fault Sourcing and Maintenance
- Appendix A - Specifications
- Appendix B - F/O Cleaning Procedure
AXELL BSF-4004 BSF0038 SERIES REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
1.5.2 External Interfaces
The repeater’s interfaces are located on the underside panel.
Note: The external connections at the bottom of the repeater can be protected by a cover which is
screwed in place.
The following table provides a description of the front panel ports and connections.
Port Description
Server Service antenna connection – N type connector, female
Optic SC/APC fibre optic connector through which the optic fibre is routed for
internal connections (section
3.5).
Power
Plinth connection for routing power for internal connection (section
3.7)
Alarms Plinth connector for routing external alarms and relay wiring cable for
internal connections (section
3.6).
GND
Grounding lug (section
3.3)
Power Fiber inputGround
Server
antenna
External
alarms
© Axell Wireless Ltd Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0 5