User Manual

AXELL 3604 A284 SERIES UHF REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

Set the Attenuation as follows:

Under the selected Chain (channel), in the Downlink section, set DL Attenuation

to the maximum value. The values shown in the figure below are for example

only.

Lower the Attenuation level step by step until the desired output power level is

reached (zero attenuation = maximum gain).

NOTE: Since the base station is more sensitive than a mobile unit there may be less signal

gain from the mobile unit in to the base station (UL) than in the opposite direction. The

uplink attenuation can be adjusted more accurately later on, once test signal measurements

have been completed.

Set to maximum

value