Installation Guide
Table Of Contents
- Compliance with FCC
- Compliance with IC
- General Safety Warnings Concerning Use of System
- Table of Contents
- 1 INTRODUCTION
- 2 INSTALLATION REQUIREMENTS and PROCEDURE
- 2.1 Service Antenna Requirements
- 2.2 Infrastructure and Cabling Considerations
- 2.3 Repeater Installation
- 3 GETTING STARTED
- 4 DIRECT ACCESS MENU OPTIONS
- 5 MONITORING AND FAULT SOURCING
- 6 MAINTENANCE
- APPENDIX A – SPECIFICATIONS
- APPENDIX B – F/O CLEANING PROCEDURE
MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 28-Jan-16 www.cobham.com/wireless
Doc. No. 00046UM Rev. 2.1
Page | 45
4.3 General Parameters
This section describes the following options:
• Viewing site information and repeater information (repeater ID, SW and HW versions, etc.)
• Date and Time
• Configuring external alarms
• Setting Ethernet IP Address
4.3.1 Viewing MBF-40 Site Identification and General
Information
The Site Information button provides access to MBF-40 hardware and software version
information.
To view MBF-40 Site Information
Click the Config menu button and click on the Site Information icon. Two areas are displayed:
• Control Module – provides hardware and software version information.
• Site Information – provides MBF-40 identification information.
Figure 4-2. MBF-40 Site Information