Installation Guide
Table Of Contents
- Compliance with FCC
- Compliance with IC
- General Safety Warnings Concerning Use of System
- Table of Contents
- 1 INTRODUCTION
- 2 INSTALLATION REQUIREMENTS and PROCEDURE
- 2.1 Service Antenna Requirements
- 2.2 Infrastructure and Cabling Considerations
- 2.3 Repeater Installation
- 3 GETTING STARTED
- 4 DIRECT ACCESS MENU OPTIONS
- 5 MONITORING AND FAULT SOURCING
- 6 MAINTENANCE
- APPENDIX A – SPECIFICATIONS
- APPENDIX B – F/O CLEANING PROCEDURE
MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 28-Jan-16 www.cobham.com/wireless
Doc. No. 00046UM Rev. 2.1
Page | 35
3.2 Navigating the Web Interface
MBF-40 is managed via WEB GUI, where the WEB GUI options differ according to the type of
session.
This section describes the following WEB GUI options:
• Home screen – always available when a session is opened to the repeater.
• Menu buttons – available only when a DIRECT session is opened to the repeater; when an OMU
II session is opened to the repeater, the menu button options are NOT available.
3.2.1 The Home Screen
The Home screen described below is always displayed when a session is opened to the repeater;
however, the Menu options are only available with a direct session (not via OMU II).
The Home screen WITH the menu options is shown below. The various areas are briefly described in
the following page.
Figure 3-4: MBF-40 Home Screen
Menu options - available ONLY with a
DIRECT session to the repeater (not
via OMU II)
General
External
Alarms
UL and DL
Output
Control
Options
Fiber Optic
Options
Power
Monitoring
Options