Installation Guide
Table Of Contents
- Compliance with FCC
- Compliance with IC
- General Safety Warnings Concerning Use of System
- Table of Contents
- 1 INTRODUCTION
- 2 INSTALLATION REQUIREMENTS and PROCEDURE
- 2.1 Service Antenna Requirements
- 2.2 Infrastructure and Cabling Considerations
- 2.3 Repeater Installation
- 3 GETTING STARTED
- 4 DIRECT ACCESS MENU OPTIONS
- 5 MONITORING AND FAULT SOURCING
- 6 MAINTENANCE
- APPENDIX A – SPECIFICATIONS
- APPENDIX B – F/O CLEANING PROCEDURE
MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 28-Jan-16 www.cobham.com/wireless
Doc. No. 00046UM Rev. 2.1
Page | 5
1.5.3 Internal Interfaces
This section shows the internal interfaces relevant to the following operations:
• Connect power
• Connect optic Fibers
• Connect alarms (if relevant)
• Power-on (Power-ON switch)
• Optional – USB/Ethernet port for local setup
NOTE: The internal view of your repeater may be different, but the general location of the relevant items is the
same.
Figure 1-5: MBF Repeater with Door Open
Alarms and relay connections.
(Section
3.6)
USB local setup connections. Refer to
Section
7.4 for LED descriptions
Ethernet Local Setup port
Battery pack
Control module
Power and battery switches.
See Section
3.9
Optic converter module
Optic converter module LEDs
Optic Fiber connection
(Section 3.7)
Power connections
(Section 3.9)