Installation Guide
Table Of Contents
- Compliance with FCC
- Compliance with IC
- General Safety Warnings Concerning Use of System
- Table of Contents
- 1 INTRODUCTION
- 2 INSTALLATION REQUIREMENTS and PROCEDURE
- 2.1 Service Antenna Requirements
- 2.2 Infrastructure and Cabling Considerations
- 2.3 Repeater Installation
- 3 GETTING STARTED
- 4 DIRECT ACCESS MENU OPTIONS
- 5 MONITORING AND FAULT SOURCING
- 6 MAINTENANCE
- APPENDIX A – SPECIFICATIONS
- APPENDIX B – F/O CLEANING PROCEDURE
MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 28-Jan-16 www.cobham.com/wireless
Doc. No. 00046UM Rev. 2.1
Page | 3
1.3 Operating Temperature
The MBF-40 is designed primarily for multi carrier purposes. If the repeater is run at full output
power over a long period of time, additional, external cooling may be required; this can take the
form of air-conditioning or an external fan assembly.
NOTE: The repeater is equipped with a power management function that steps down the power and, if needed,
fully shuts down the amplifier chains until temperature reaches normal values.
1.4 MBF-40 Management Web GUI
MBF-40 is remotely commissioned and monitored via an OMUII session. Local access to the unit is
not required for commissioning.
Additional configuration and troubleshooting options are available via a direct connection to the MBF-
40 IP address. A direct session can be opened locally or remotely.
NOTE: Direct remote communication requires connecting the MBF-40 to an Ethernet network.
1.5 MBF-40 Basic Interfaces
The MBF unit provides several types of interfaces:
• Lock and screws for protection and security
• External service antenna and GND connections
• Internal connections for power, Fiber optics and alarm cables routed via openings in the front
panel.
• Internal USB and Ethernet connections for local setup via Web GUI