User Manual
Table Of Contents
- MBF, Multi Band Repeater
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Commissioning Advice
- 4 Setup
- 5 Troubleshooting
- 6 Maintenance
- 7 Modem Communication
- 8 Specifications
AXELL MBF MULI-BAND FIBRE REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
12 © Axell Wireless Ltd
Attach the fibre to
the fibre optic
converter inside the
repeater.
Note!
Clean the fibre connector before it is connected, see instruction
below.
2.5.1 Cleaning Optical Connectors
Optical reflections from a discontinuity such as a poor connector interface
appear on an RF spectrum analyzer trace as stable variations in the noise
floor amplitude that are periodic with RF frequency. If the reflection is bad
enough, it could impact the system performance. By far, the most common
cause for a large discrete reflection is a dirty optical connector. A bit of
dust or oil from a finger can easily interfere with, or block this light.
Fortunately, it is very easy to clean the connector.
Be sure to use the correct procedure for the given connector. When
disconnected, cap the FC/APC connector to keep it clean and prevent
scratching the tip of the ferrule.
Alternative 1
Swipe the tip of the ferule 2-3 times
with a cotton swab soaked in
alcohol. Let it air dry.
Alternative 2
Use a product specially designed for
the purpose.