User Manual
Table Of Contents
- MBF, Multi Band Repeater
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Commissioning Advice
- 4 Setup
- 5 Troubleshooting
- 6 Maintenance
- 7 Modem Communication
- 8 Specifications
AXELL MBF MULI-BAND FIBRE REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
10 © Axell Wireless Ltd
The primary protective device is part of the site installation and is not supplied by Axell
Wireless. Coaxial lightning protection is normally one of these three types: Gas capsule,
High-pass and Bandpass.
There also need to be a protective device installed on the power supply cord.
Protective device installed in connection with the power supply
2
2
.
.
5
5
F
F
i
i
b
b
r
r
e
e
O
O
p
p
t
t
i
i
c
c
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
This product is equipped with class 3B lasers, as per definition in EN 60825-1.
Caution!!!
Un-terminated optical receptacles may emit laser radiation.
Do not stare into beam or view with optical instruments.
Use the following over the complete link between the Repeater and OMU:
• Use angled APC connectors at 8deg angle
• APC type ODF connections
• Mono-mode type fibre
Select fibre
Recommended fibre cable is single mode 9/125.
Connect the fibre
The casing of the repeater is equipped with an inlet. The inlet is designed
to go with a corrugated hose, which is included in the shipment.
The hose, together with the rubber seal meet the protection standard IP65.
1. Run the
fibre
through the
hose
2. Run the
fibre
through
the inlet in
the
repeater