User Manual
Table Of Contents
- MBF, Multi Band Repeater
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Commissioning Advice
- 4 Setup
- 5 Troubleshooting
- 6 Maintenance
- 7 Modem Communication
- 8 Specifications
AXELL MBF MULI-BAND FIBRE REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
8 © Axell Wireless Ltd
2.2.1 Ensure Proper Cooling
• Mount the repeater so that heat can be dispersed from it.
• The repeater wall mounting kit ensures an optimum airflow between the wall and the repeater
itself.
• Do not block this air channel as it will cause the MTBF of the repeater to drop dramatically, or
even in the worst case cause the repeater to fail completely.
• If possible use a wall in the shadow to minimize the overall sun loading. If sufficient shielding
cannot be obtained, an additional sun shield should be mounted.
2-1. Example of a sun shield
2
2
.
.
3
3
G
G
r
r
o
o
u
u
n
n
d
d
i
i
n
n
g
g
• Connect the grounding protection
.
• Ensure that good grounding protection measures are taken to
create a reliable repeater site.
• Make sure to use adequately dimensioned grounding cables.
The minimum recommended conductive area for a
grounding cable is 16mm
2
• The antenna cabling should be connected to ground every
10m by a reliable grounding kit.
• Make sure the grounding product used is suitable for the kind
and size of cable being used.
• Connect the repeater box bolt to the same ground.
Ground