User Manual
Table Of Contents
- MBF, Multi Band Repeater
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Commissioning Advice
- 4 Setup
- 5 Troubleshooting
- 6 Maintenance
- 7 Modem Communication
- 8 Specifications
AXELL MBF MULI-BAND FIBER REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 5
1.6.3 Internal Interfaces
You will need to open the Repeater in order to:
• Connect power and optic fibres
• Connect alarms (if relevant)
• Power up the Repeater
• Connect to the LMT (RS232 connection) for local setup
1-2. Single band repeater with door open
Controller module RS232 local
setup connection. Refer to section
4.1.2 for LED descriptions
Alarms and relay connections.
Refer to section 2.7 for
descriptions.
F/O Converter LEDs (section
4.1.1) and optic connector to
which routed optic fibre is
connected (section 2.6)
Power connections.
Controller module RS232 local
setup connection. Refer to section
4.1.2 for LED descriptions
Rechargeable battery pack
Power and battery switches