User Manual
Table Of Contents
- Optical Master Unit
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Setup
- 3.1 Initiate Local Communication
- 3.2 Configure the OMU
- 3.3 Fiber Loss Compensation and Master Attentuation
- 3.4 Integration into AEM
- 3.5 Set Up OMU-Repeater System
- 3.6 Balance the System
- 3.7 Initiate Fiber Loss Compensation
- 3.8 Set up Remote Communication
- 3.9 Integrate into the AEM
- 3.10 Installation Examples
- 4 Troubleshooting
- 5 Maintenance
- 6 Specifications
AXELL OPTICAL MASTER UNIT
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd V
Electrostatic Sensitivity
Observe electrostatic precautionary procedures.
Caution
ESD = Electrostatic Discharge Sensitive Device
Semiconductor transmitters and receivers provide highly reliable performance when operated in
conformity with their intended design. However, a semiconductor may be damaged by an
electrostatic charge inadvertently imposed by careless handling.
Static electricity can be conducted to the semiconductor chip from the centre pin of the RF input
connector, and through the AC connector pins. When unpacking and otherwise handling the OMU,
follow ESD precautionary procedures including use of grounded wrist straps, grounded workbench
surfaces, and grounded floor mats.
References
References to standards apply as relevant to the repeater type being connected to the OMU. Please
see respective repeater manual for details.