User Manual
Table Of Contents
- Optical Master Unit
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Setup
- 3.1 Initiate Local Communication
- 3.2 Configure the OMU
- 3.3 Fiber Loss Compensation and Master Attentuation
- 3.4 Integration into AEM
- 3.5 Set Up OMU-Repeater System
- 3.6 Balance the System
- 3.7 Initiate Fiber Loss Compensation
- 3.8 Set up Remote Communication
- 3.9 Integrate into the AEM
- 3.10 Installation Examples
- 4 Troubleshooting
- 5 Maintenance
- 6 Specifications
AXELL OPTICAL MASTER UNIT
PRODUCT DESCRIPTION AND USER’S MANUAL
IV © Axell Wireless Ltd
Safety to Personnel
Before installing or replacing any of the equipment, the entire manual should be read and understood.
The user needs to supply the appropriate AC or DC power to the OMU System. Incorrect power
settings can damage the OMU System and may cause injury to the user.
Throughout this manual, there are "Caution" warnings. "Caution" calls attention to a procedure or
practice, which, if ignored, may result in injury or damage to the system, system component or even
the user. Do not perform any procedure preceded by a "Caution" until the described conditions are
fully understood and met.
CAUTION! This notice calls attention to a procedure or practice that, if ignored, may result in
personal injury or in damage to the system or system component. Do not perform any procedure
preceded by a "Caution" until described conditions are fully understood and met.
Safety to Equipment
When installing, replacing or using this product, observe all safety precautions during handling and
operation. Failure to comply with the safety precautions and with specific precautions described
elsewhere in this manual violates the safety standards of the design, manufacture, and intended use of
this product. Axell Wireless assumes no liability for the customer's failure to comply with these
precautions. This entire manual should be read and understood before operating or maintaining the
System.
Class 3B Laser
This product is equipped with Class 3B lasers, as per definition in EN 60825-1.
Caution!!!
Un-terminated optical receptacles may emit laser radiation.
Do not stare into beam or view with optical instruments.
Optical transmitters in the opto-module can emit high energy invisible laser radiation. There is a risk
for permanent damage to the eye.
Always use protective cover on all cables and connectors which are not connected. Never look
straight into a fibre cable or a connector. Consider that a fibre can carry transmission in both
directions.
During handling of laser cables or connections ensure that the source is switched off. Regard all open
connectors with respect and direct them in a safe direction and never towards a reflecting surface.
Reflected laser radiation should be regarded as equally hazardous as direct radiation.