User Manual
Table Of Contents
- Optical Master Unit
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Setup
- 3.1 Initiate Local Communication
- 3.2 Configure the OMU
- 3.3 Fiber Loss Compensation and Master Attentuation
- 3.4 Integration into AEM
- 3.5 Set Up OMU-Repeater System
- 3.6 Balance the System
- 3.7 Initiate Fiber Loss Compensation
- 3.8 Set up Remote Communication
- 3.9 Integrate into the AEM
- 3.10 Installation Examples
- 4 Troubleshooting
- 5 Maintenance
- 6 Specifications
OPTICAL MASTER UNIT
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 31
3.8.2.1 Modem Configuration, not using GPRS
Select
“Configuration”
and
“Communication”
Select Data Call
Initialization string
Connect times
AEM addressed are
set via the AEM
Select Data Call
Set the modem initialization string. This string differs between networks.
Primary recommendation is AT+CBST=71,0,1;\Q3. If remote
communication cannot be established try 7,0,1 or 0,0,1 or 7,0,3. For more
information please refer to the section on Troubleshooting Remote
Communication.
Tick “Enable Automatic Modem Power Cycling” for the modem to be
power cycled once every 24 hours. Set the time at which the modem should
be tested. This function ensures that the repeater always is logged in to the
network.
3.8.2.2 Modem Configuration, using GPRS
Select
“Configuration”
and
“Communication”
2004-01-01