User Manual
Table Of Contents
- Optical Master Unit
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Setup
- 3.1 Initiate Local Communication
- 3.2 Configure the OMU
- 3.3 Fiber Loss Compensation and Master Attentuation
- 3.4 Integration into AEM
- 3.5 Set Up OMU-Repeater System
- 3.6 Balance the System
- 3.7 Initiate Fiber Loss Compensation
- 3.8 Set up Remote Communication
- 3.9 Integrate into the AEM
- 3.10 Installation Examples
- 4 Troubleshooting
- 5 Maintenance
- 6 Specifications
AXELL OPTICAL MASTER UNIT
PRODUCT DESCRIPTION AND USER’S MANUAL
24 © Axell Wireless Ltd
Fill in the information for each repeater in the pop up window.
Serial number
The serial number consists of 4 letter and/or
digits. It is printed on the yellow label on the
repeater
Bus number
When OMUs are cascaded they run on different buses.
OMU 1 and OMU 3 is on “bus “0 and OMU 2 and
OMU 4 in on” bus 1”..
Controller type
Select the correct repeater controller based on the
illustrations
Baud rate
The default value changes when the controller
type is selected. (Other values are also available
for specific situations not described in this
manual.)
Slot Assignment
Tick the button that corresponds to the fibre optic
converter the repeater is connected to.
Note! To confirm an installation or to check the
present configuration select a fibre optic converter
and click the button
.
If a
repeater is installed in this position the repeater
serial number will be presented.
Check the LEDs
on the Fiber Optic
Converters
The Fiber Optic Converter contains two optical alarm sources. These are
alarms for transmitted and received optical signal level. Refer to Error!
Reference source not found.