User Manual
Table Of Contents
- Optical Master Unit
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Warrantee
- Table of Contents
- 1 Introduction
- 2 Installation
- 3 Setup
- 3.1 Initiate Local Communication
- 3.2 Configure the OMU
- 3.3 Fiber Loss Compensation and Master Attentuation
- 3.4 Integration into AEM
- 3.5 Set Up OMU-Repeater System
- 3.6 Balance the System
- 3.7 Initiate Fiber Loss Compensation
- 3.8 Set up Remote Communication
- 3.9 Integrate into the AEM
- 3.10 Installation Examples
- 4 Troubleshooting
- 5 Maintenance
- 6 Specifications
OPTICAL MASTER UNIT
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 9
1
1
.
.
5
5
R
R
e
e
a
a
r
r
P
P
a
a
n
n
e
e
l
l
Note: The rear-panel layout can vary depending on the configuration.
Th
e rear panel provides the following
functions:
• Power - Plinths for power connections –
requires opening the rear panel.
• GND - screw for earthing
• RF input - N-connector for RF input. There
is one connector if the Rx/Tx input is
combined and two connections if the Rx
and Tx are to be fed separately.
To gain access to the plinths for power connections,
duplex filter (for some models), optional attenuators
and optional coupler the back panel needs to be
opened. It is fastened with 4 screws.
An OMU with one RF in/out
The images to the right show the closed panel and
open panel (required for input power connections).
The inside of the back lid with two plinths for power
connections, a duplex filter and one RF in/out