User Manual

MBF, Multi Band Repeater

PRODUCT DESCRIPTION AND USER'S MANUAL

A fallback functionality is available, which means that the Control Module falls back to the primary address

after a configurable number of minutes. If this interval is set to 0, the fallback will not be performed. A user

can always force the Control Module to fall back to the primary address.

Note! When the repeater is integrated to the Axell Element Manager system, these addresses are set by the

AEM, why they need not be configured during site installation.

5.7.2.4

Modem Verification

When the remote configuration has been set up the communication can be verified using the modem feature

of the RMC and dialling the data number. The remote communication is verified as soon as a successful

remote login to the repeater has been performed.

However, as a first step, it is recommended to verify that the modem is initialized correctly. After configuring

the modem using the RMC, make sure to initiate a power cycling of the modem. This is done from the RMC

menu.

Click on the drop-down menu

Actions, choose Power Cycle

Modem on Logout

An immediate power cycling is initiated after which the modem is initialized and registered onto the network.

The modem is now ready for remote access.

Ensure a successful configuration by observing the modem LED as described below.

Note! This LED behaviour is valid only for GSM modems. Other modem types will be added in later

editions.

Green LED – Modem Status

On Depending on type of call:

Voice call: Connected to remote party

Data call: Connected to remote party or exchange of

parameters while setting up or disconnecting a call

Flashing

(irregular)

Indicates GPSR data transfer. When a GPRS transfer is

in progress the LED goes on within 1 second after data

packets were exchanged. Flash duration in

approximately 0.5s.

75ms on/75ms off/75ms on/3s off

One or more GPRS contexts activated

75ms on/3s off

Logged to network (monitoring control channels and

user interactions). No call in progress

600ms on/600ms off

No SIM card inserted, or no PIN entered, or network

search in progress, or ongoing user authentications, or

network login in progress

Off Modem is off

Verify the remote communication either by having someone attempting to integrate the repeater from the

Axell Element Manager, or by dialling the repeater using the Repeater Maintenance Console.