User Manual

MBF, Multi Band Repeater

PRODUCT DESCRIPTION AND USER'S MANUAL

Safety Instructions and Warnings

Guarantees

All antennas must be installed with lightning protection. Damage to power modules, as a result of lightning

are not covered by the warranty.

Switching on AC or DC power prior to the connection of antenna cables is regarded as faulty installation

procedure and therefore not covered by the Axell Wireless warranty.

The repeater box should be closed using the two screws. The screws must be fully tightened. Failure to do so

may affect the IP65 compliancy and therefore any warranty.

Safety to Personnel

Before installing or replacing any of the equipment, the entire manual should be read and understood. The

user needs to supply the appropriate AC or DC power to the repeater. Incorrect power settings can damage

the repeater and may cause injury to the user.

Caution

Please be aware that the equipment may, during certain conditions become very warm

and can cause minor injuries if handled without any protection, such as gloves.

Throughout this manual, there are "Caution" warnings. "Caution" calls attention to a procedure or practice,

which, if ignored, may result in injury or damage to the system, system component or even the user. Do not

perform any procedure preceded by a "Caution" until the described conditions are fully understood and met.

Caution

This notice calls attention to a procedure or practice that, if ignored,

may result in personal injury or in damage to the system or system component.

Do not perform any procedure preceded by a “Caution” until described

conditions are fully understood and met.

Safety to Equipment

When installing, replacing or using this product, observe all safety precautions during handling and operation.

Failure to comply with the following general safety precautions and with specific precautions described

elsewhere in this manual violates the safety standards of the design, manufacture, and intended use of this

product. Axell Wireless assumes no liability for the customer's failure to comply with these precautions. This

entire manual should be read and understood before operating or maintaining the repeater.

Electrostatic Sensitivity

Observe electrostatic precautionary procedures.

Caution

ESD = Electrostatic Discharge Sensitive Device

Semiconductor transmitters and receivers provide highly reliable performance when operated in conformity

with their intended design. However, a semiconductor may be damaged by an electrostatic discharge

inadvertently imposed by careless handling.

Static electricity can be conducted to the semiconductor chip from the centre pin of the RF input connector,

and through the AC connector pins. When unpacking and otherwise handling the repeater, follow ESD

precautionary procedures including use of grounded wrist straps, grounded workbench surfaces, and

grounded floor mats.