User Manual

Document Name: Common Commands and Attributes v1.3.0 Revision: 1.2
14.1.16 GPR PTR – Persistence timer
14.1.16.1 Overview
Sets the timer on how often the system should check for a GPRS interface.
14.1.16.2 Usage
Attribute Type: Read / Write
This timer sets the time how often the system should check that the network is
enabled and operational.
Valid values are between 5 seconds to 600 seconds.
Format on setting parameter:
SET GPR PTR <time>
Where <time> is 5 to 600 indicating the check timer interval in seconds.
Example:
SET GPR PTR 90
Sets the timer to 90 seconds (1½ minute) intervals.
Format on getting parameter:
GET GPR PTR
Reply:
<time>
Where time is the current time of the interval to check for the existence of a GPRS
interface.
Example:
GET GPR PTR
Reply:
35
Indicating that the system should check for an existing interface every 35 seconds.
14.1.17 GPR RTE – Default route enable
14.1.17.1 Overview
This tells the system to use network default route to GPRS or not.
14.1.17.2 Usage
Attribute Type: Read / Write.
Format on setting parameter:
SET GPR RTE <enable>
Where <enable> is 1 to enable default route through this interface and 0 is to
disable the default route through this interface.
Common Commands and Attributes 118/123