User's Manual

Axell BSF3604-490-510-DP-AC (61-103001) Repeater

Product Description and User’s Manual

5 BSF-3604 Commissioning

After the repeater is connected, it is identified by the OMU II via the fiber connection and the unit is

commissioned from the OMU II. The commissioning process consists of a few simple steps.

To commission the BSF-3604 - overview:

1. Open an OMU II session. This is used to access the BSF-3604 configuration window (via

OMU II).

2. Perform Optical Loss Adjustment.

3. Set the required RF attenuation and gain levels

4. Assign the unit a recognizable name (according to its location).

5.1 Open a Session to the BSF-3604 via the OMU II

1. Open a local or remote session to the host OMU II:

 Remote session – open a Browser session in the same subnet as the host OMU II and

enter the IP of the host OMU II (see OMU user manual for detailed procedure). Enter the

OMU II User Name (e.g. axell) and Password (provided by your system administrator).

 Local session– connect to the OMU II Control Module's USB or Ethernet ports. Enter the

OMU II User Name (e.g. axell) and Password (provided by your system administrator).

 After accessing an OMU II session, commission the BSF-3604 according to the following

section.

Figure 5-1: Connection to OMU II

Connect to either the USB port

or the Ethernet port