User's Manual

Axell BSF3604-490-510-DP-AC (61-103001) Repeater

Product Description and User’s Manual

4.7.3 Power ON

4.7.3.1 Switching Power ON

Make sure the antenna cables or 50Ω terminations are connected to the

repeater’s antenna connectors before the repeater is turned on.

1. Set the PSU On/Standby Switch to On

2. Set the Battery On/Off switch to On.

Figure 4-14: BSF-3604 Power Module

NOTE: With the PSU module on/standby switch in the standby position the repeater is still

connected to the AC power supply but is not operational.

4.7.3.2 Verifying LEDs

Verify the LEDs from the following modules are indicating correct operation (see section 0):

 Control module

 F/O converter

 Power supply modules

4.8 Closing and Securing the Repeater

Close the door, tighten the quarter-turn door catches and lock repeater with the keys provided.

Continue with the following section “Commissioning” to setup the repeater.

NOTE: The two door catches must be fully closed and locked. Failure to do so will affect the IP65

compliancy and therefore any warranty.