User's Manual

Axell BSF3604-490-510-DP-AC (61-103001) Repeater

Product Description and User’s Manual

3. Remove any protective caps from the SC/APC connector and SC/APC receptacle and mate

the free connector to the receptacle.

NOTE: Clean the fiber connector before connecting it to the system. See instruction in

Appendix B - F/O Cleaning Procedure.

4. To ensure IP65 compliancy and provide a degree of strain relief rubber sealing insert should

be employed. The insert has a slit along one side; on the outside of the repeater, pass the

fiber optic cable through the slit in the insert and then slide the insert along the cable and into

the cable entry gland.

5. With the rubber sealing insert sitting inside the

cable entry gland, tighten the exterior nut until it

grips the rubber sealing insert - the exterior nut

acts as a collet gripping the rubber sealing insert.

Check again that there is enough cable slack

between the cable gland and the fiber optic

converter module, the cable should not be too

tight.