User's Manual

AXELL CSR 3604-3304 UHF REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

Document number: 3633B-UM

Page 43 of 67

26/10/2015

Revision. 4

Set the Attenuation as follows:

Under the selected Chain (channel), in the Downlink section, set DL Attenuation to

the maximum value. The values shown in the figure below are for example only.

Lower the Attenuation level step by step until the desired output power level is

reached (zero attenuation = maximum gain).

NOTE: Since the base station is more sensitive than a mobile unit there may be less signal

gain from the mobile unit in to the base station (UL) than in the opposite direction. The uplink

attenuation can be adjusted more accurately later on, once test signal measurements have

been completed.

Set to maximum

value