User's Manual

AXELL CSR 3604-3304 UHF REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

Document number: 3633B-UM

Page 27 of 67

26/10/2015

Revision. 4

2. Mark and drill the wall with the correct size masonry bit as specified by the fixing

manufacturer.

WARNING: It is good practice to wear goggles to protect your eyes from

flying debris when using power tools.

3. Hold the drill bit against the mark and begin drilling slowly so that the bit does not wander

from the position. The wall should be drilled to a depth which is sufficient to

accommodate the full length of the fixing.

4. Insert the fixings so that the top of the sleeve/anchor section is level with the wall surface.

5. Gently tighten the bolt by hand so that the anchor section of the fixing expands and grips

the inside of the hole.

Figure 6-3. Inserting Fixing and Tightening

6. As the bolt pulls its way in, the sides of the anchor section are forced outwards, gripping

the surrounding surface.

Figure 6-4 Anchor Sides Pushed Outwards

7. Once all four fixings are in place, carefully withdraw the four bolts.

Figure 6-5. Withdraw Bolts.

6.5.3 Hanging the Repeater on the Wall

1. Align repeater with the four fixings. Exercise great care as the repeater is very heavy (a

suitably rated heavy duty scissor lift table/trolley may be suitable for this operation).

2. Carefully insert the fixing bolts through the mounting lugs of the Repeater and into the

sleeve/anchor sections of the fixing in the wall and tighten the bolts.