User Manual
Table Of Contents
- 1. INTRODUCTION
- Scope and Purpose of Document
- Limitation of Liability Notice
- 2. SAFETY CONSIDERATIONS
- 3. EQUIPMENT OVERVIEW
- 4. SUB-UNIT MODULES
- 4.1 Bandpass Filter (02-010201)
- 4.2 Two-Way Splitter (07-002503)
- 4.3 0.25Watt 0- -30dB Switched Attenuator (10-000703)
- 4.4 11-007302 & 11-007402 Low Noise Amplifiers
- 4.4.1 Description
- 4.4.2 Technical Specification (11-007302)
- 4.4.3 Technical Specification (11-007402)
- 4.4.4 LNA ‘D’ Connector Pin-out details
- 4.4.5 Drg. # 11-007302, LNA Assembly With Alarm Relay
- 4.4.6 Drg. # 11-007370, LNA RF Circuit Diagram
- 4.4.7 Drg. # 11-007371, LNA DC Wiring Diagram
- 4.4.8 Drg. # 11-003971, LNA DC Circuit Diagram
- 4.4.9 Drg. # 11-007402, LNA Assembly With Alarm Relay
- 4.4.10 Drg. # 11-007470, LNA RF Circuit Diagram
- 4.5 12-021601 5Watt Medium Power Tetra Amplifier
- 4.6 12-022101 10Watt Power Tetra Amplifier
- 4.7 8A Mains Filter Assembly (13-003301)
- 4.8 Channel Control Module (17-002101)
- 4.9 Channel Selective Module (17-003007)
- 4.10 12V Single Relay Board (80-008901)
- 4.11 12V Switch-Mode PSU (96-300052)
- 5. INSTALLATION
- 6. FAULT FINDING & MAINTENANCE
- 6.1 General Fault Finding Procedures
- 6.2 Downlink
- 6.3 Uplink
- 6.4 Fault repair
- 6.5 Checking service
- 6.6 Service Support
- 6.7 Tools & Test Equipment
- 6.8 General Maintenance Procedures
- _
- 6.9 Module Removal (LNA’s, general procedure)
- 6.10 Module Replacement (general)
- 6.11 Power Amplifiers
- 6.12 Low Power Amplifier Replacement
- 6.13 Module Transportation
- APPENDIX A
- _
- APPENDIX B
Two Channel UHF Cell Enhancer
User Handbook
Handbook Number: 50-187601HBKM Page: 12 of 51
3.4 Parts List
AFL Part # Part Description Qty.
02-010201 6P C/L FILTER 380-500 <4 MHz SMA 4
07-002503 2 WAY SPLITTER 50/500MHz SMA 4
10-000703 1/4W 0-30dB SWITCHED ATTENUATOR 2
11-007302 LNA. 380-500MHz 20dB (C/W RELAY) GA 2
11-007402 LNA. 380-500MHz 30dB (C/W RELAY) GA 2
12-021601 TETRA 5W +12V AMPLIFIER 1
12-022101 PA 380-470MHz 10W CLASS A +12V 1
13-003301 MAINS FILTER 8AMP ASSEMBLY 1
17-000126 CELL ENHANCER LABEL 6 DIGIT 1
17-000526 CE 10W HEATSINK THERMAL GASKET 3
17-001522 BASE PLATE 560 x 345mm 17-001520&9020 1
17-001523 GREY RAL7032 H/SINK BLANKING PLATE 1
17-002101 CHANNEL CONTROL MODULE 1
17-002103 26WAY RIBBON CABLE LEAD 4
17-003007 CHAN MOD 450MHz, 30kHz B/W 8 pole 4
17-003022 MODULE PATTERNED LEAVE 4
17-003023 SUBRACK SIDE PANEL 2
17-003024 SUBRACK REAR BRACKET 2
17-003025 BOTTOM MODULE GUIDE 4
17-003029 TOP MODULE GUIDE 4
17-009020 ENCLOSURE 620 x 420 x 250 (3 H/S) ALU 1
80-008901 12V RELAY PCB ASSEMBLY **NO LED** 1
80-032320 10W PA HEATSINK 2
90-100009 CABLE 3CORE MAINS '6 A' USA COLOURS 1
90-400006 6 pin BULGIN ALARM LEAD 1
91-030002 N ADAPTOR PANEL FEMALE:FEMALE 2
91-130001 SMA ADAPT 'T' ALL FEMALE 3 GHz 2
91-500011 PWR 3POLE PNL PLUG SEALED IP68 1
91-500015 PWR CON CAP SEALED with INT. THREAD 2
91-500016 PWR 6POLE PNL PLUG SEALED IP68 1
91-600005 'D' 9 WAY SOCKET S/B TERM 4
91-600007 'D' 9 WAY BLACK SHELL 4
91-600019 'D'15 WAY SHELL (2W7) 2
91-640004 LARGE PIN FOR 91-660001 D SOCKET 4
91-660001 2W5 MIXED D TYPE SOCKET (7 WAY) 2
91-700017 ICD 15 WAY 0.1' CONNECTOR 1
92-280033 Captive Screw 8
96-300052 JWS150-12/A PSU (COUTANT LAMBDA) 1
96-700034 LED RED 5mm IP67 INTEGRAL RES. 24V 1
96-700035 LED GREEN 5mm IP67 INTEGRAL RES 24V 1
96-900017 AC TRIP SWITCH (3 AMP M.C.B.) 1
97-000002 BLACK MODULE CAGE RUNNER 8
97-300010 C/E SUPPLY INPUT COVER 1
97-400011 BLACK POLYMIDE HANDLE 120mm 2
97-400012 SCHROFF BLACK DOOR LOCK 20234 024 2
97-600002 SUBRACK M2.5 STD TAP 2
97-900004 RUBBER FOOT FOR CELL ENHANCERS 4