Handbook
Table Of Contents
- AMENDMENT LIST RECORD SHEET
- INTRODUCTION
- 1.SAFETY CONSIDERATIONS
- 2.OVERVIEW/SYSTEM DESCRIPTION
- 3.SPECIFICATION
- 3.150-063701 Parts Lists
- 3.1.1Base Antenna Side UHF Duplex/PA Shelf 50-063702 Parts List
- 3.1.2Downlink UHF 5 Channel Shelf 50-063703 Parts List
- 3.1.3Uplink UHF 4 Channel Shelf 50-063704 Parts List
- 3.1.4Tunnel side UHF Duplex/PA Shelf 50-063705 Parts List
- 3.1.5UHF Simplex Shelf 50-063706 Parts List
- 3.1.6Power Supply Shelf 50-063707 Parts List
- 3.2Technical Specification
- 3.3Mechanical Specification
- 3.150-063701 Parts Lists
- 4.SYSTEM DRAWINGS
- 4.1Drg. No. 50-063751, Channelised Cell Enhancer Rack Layout Drawing
- 4.2Drg. No. 50-063781, Channelised Cell Enhancer System Diagram
- 4.3Drg. No. 50-063792, Base Side Duplex Shelf Outline Drawing
- 4.3Drg. No. 50-063793, Downlink Channels Shelf Outline Drawing
- 4.4Drg. No. 50-063794, Uplink Channels Shelf Outline Drawing
- 4.5Drg. No. 50-063795, Tunnel Side Duplexer Shelf Outline Drawing
- 4.6Drg. No. 50-063796, UHF Simplex Shelf Outline Drawing
- 4.7Drg. No. 50-063797, Power Supply Shelf Outline Drawing
- 5.SUB-UNIT MODULES
- 5.1UHF Duplex Shelf 50-063702
- 5.25 Channel UHF Downlink Shelf 50-063703
- 5.3UHF Uplink 4 Channel Shelf 50-063704
- 5.4UHF Duplex/PA Shelf 50-063705
- 5.5UHF Simplex Channel Shelf 60-063706
- 5.6Power Supply Shelf 50-063707
- 6.INSTALLATION
- 7.MAINTENANCE
- APPENDIX AINITIAL EQUIPMENT SET-UP CALCULATIONS
Denver Channelised CE
User/Maintenance Handbook
Handbook Nō.-50-063708HBKM Issue No:-2
Date:-03/11/2003
Page:-
34 of 51
5.1.5 Low Noise Amplifiers (11-006102, 11-007302 & 11-007402)
5.1.5.1 Description
The low noise amplifiers used are double stage solid-state low-noise amplifiers. 11-
006102 is a low noise amplifier with a 1Watt power device in its final stage, enabling it to
be used as a driver for the 20W power amplifier. Class A circuitry is used in the units to
ensure excellent linearity over a very wide dynamic range. The two active devices are
very moderately rated to provide a long trouble-free working life. There are no
adjustments on these amplifiers, and in the unlikely event of failure the entire amplifier
should be replaced.
5.1.5.2 Technical Specification, 11-007302
PARAMETER SPECIFICATION
Frequency range: 380-500MHz
Bandwidth: <140MHz
Gain: 20-22dB
1dB Compression Point: +23.5dB (typical)
3rd order intercept: +36dB (typical)
Input/Output return loss: >20dB
Noise figure: <1.3dB
Connectors: SMA female
Supply: 200-230mA @ 24V DC
operational: -30°C to +60°C
Temperature range:
storage: -30°C to +70°C
Weight: <300gm
Size: 90 x 55 x 30.2mm (case only)