User Manual
Table Of Contents
- AMENDMENT LIST RECORD SHEET
- INTRODUCTION
- 1.SAFETY CONSIDERATIONS
- 2.OVERVIEW/SYSTEM DESCRIPTION
- 3.SPECIFICATION
- 4.SYSTEM DRAWINGS
- 5.SUB-UNIT MODULES
- 5.1VTA Downlink Duplexer Shelf 60-025302 (4U chassis)
- 5.2VTA Downlink Amplifier Shelf (50-025303, 8U Chassis)
- 5.2.1UHF 3dB Splitter (05-002603)
- 5.2.2¼Watt 0- -30dB Switched Attenuator \(10-00
- 5.2.3Low Noise Amplifier (11-006102)
- 5.2.4Low Noise Amplifiers (11-007302 & 11-007402)
- 5.2.4.1Description
- 5.2.4.2Technical Specification, (11-007302)
- 5.2.4.3Technical Specification (11-007402)
- 5.2.4.4Drg. No. 11-007302, LNA Assembly With Alarm Relay
- 5.2.4.5Drg. No. 11-007370, LNA RF Circuit Diagram
- 5.2.4.6Drg. No. 11-007371, LNA DC Wiring Diagram
- 5.2.5.7Drg. No. 11-003971, LNA DC Circuit Diagram
- 5.2.63 Stage Amplifier Alarm Boards (12-002201)
- 5.2.7450MHz 20W Power Amplifier (12-004201)
- 5.2.8Single DC/DC Converter (13-001702)
- 5.2.924V Single Relay Board (80-008902)
- 5.2.1024V 410W Power Supply (96-300054)
- 5.3VTA Downlink Channel Shelf (50-025304)
- 5.4VTA Uplink Duplexer Shelf (50-025305, 4U Chassis)
- 5.5VTA Uplink Amplifier Shelf (50-025306, 8U Chassis)
- 5.5.120Watt Class A Power Amplifier (12-016301)
- 5.5.2Automatic Gain Control (17-001101, Det. & 17-001201, Atten.)
- 5.5.2.1Description
- 5.5.2.2Technical Specification
- 5.5.2.3Drg. No. 17-001101, ACG Detector Assembly
- 5.5.2.4Drg. No. 17-001171, AGC Detector Circuit Diagram
- 5.5.2.5Drg. No. 17-001171C, AGC Detector Parts List
- 5.5.2.6Drg. No. 17-001201, AGC Attenuator Assembly Drawing
- 5.5.2.7Drg. No. 17-001270, AGC Attenuator Circuit Diagram
- 5.5.2.8Drg. No. 17-001270C, AGC Attenuator Parts List
- 6.INSTALLATION
- 7.MAINTENANCE
- APPENDIX AINITIAL EQUIPMENT SET-UP CALCULATIONS
9 Way Channelised UHF Cell Enhancer
Maintenance Handbook
H/book Number:-50-025301HBKM
Issue No:-
1
Date:-04/07/2003
Page:-
16 of 69
3.2 Technical Specification
PARAMETER SPECIFICATION
Downlink Frequency Range: 491.4-492.2MHz
Single Downlink Channel Frequency: 485.5875MHz
Uplink Frequency Range: 488.4-489.6MHz
Single Uplink Frequency: 485.5875MHz
12.5kHz adjacent channel >20dBChannel Bandwidth selectivity:
25kHz adjacent channel >80dB
Number of Channels: 9
Number of ports: 4
RF Connectors: N type, female
Impedance: 50
VSWR: Better than 1.5:1
Sensitivity: 0.35 microvolts @ 12dB SINAD
Downlink Output Power: 40 Watts
Uplink Output Power: 20Watts
Uplink TOI: 50dBm
Downlink TOI: 50dBm
RF level per carrier: >+23dBm
Passband ripple: <±1.5dB
Noise figure: <6dB (@max gain)
Gain: 96dB
Gain adjustment: 0-30dB (in 2dB steps)
In band spurious: Better than –36dBm
Spurious up to 3GHz: Better than –90dBc
Input AC Supply: 120V AC
Consumption: 300 Watts
Amplifiers
Channel phase unlock
Alarms:
(Volt-free relay contacts)
PSU Failure
MTBF: 80,000 Hrs.
Housing: 19” Rack mounted