Specifications

SAFETY WARNINGS ENG
Pag. 7
3.3 REMOVING THE TOP COVER
To change any jumpers or set the voltage changeover you must remove the top cover of the unit to access
the main boards. Remove all 6 screws holding the cover in place, then lift it off.
Use care when working inside the unit.
Uninsulated dangerous voltage are inside the enclosure, voltage that may be sufficient to
constitute a risk of shock.
Always disconnect to AC Mains before removing the top cover
3.4 GROUNDING
• THIS EQUIPMENT MUST BE EARTHED.
The chassis is always connected to mains earth to ensure your safety: check your mains wiring and earthing
before switching on.
NOTE: inside the unit, audio 0V is always DC decoupled from mains earth (ground lifted) to avoid
ground loop problems.