Specifications

CONNECTIONS AND SETTINGS ENG
Pag. 11
5.3 MONO / STEREO INPUT MODE
Using the Stereo input setting, both Left and Right signals are directed to their respective output paths. In
the Mono input configuration the Left input signal is replicated on the Right internal bus, while the Right
input connector is disconnected. Thus, provide the LEFT channel only. See Block Diagram - Chapter 6.
The Mono / Stereo input mode may be set by moving the jumper J18 located on the front board behind the
INPUT FIX / ADJ switcher, as shown in the following figure:
STEREO input MODE (default) (L ⇒ L & R ⇒ R)
MONO input MODE (L ⇒ L & R)
5.4 OSCILLATOR ADJUSTMENT
The oscillator frequency and the injection levels can be easily adjusted via trimmers P12 and P1, placed on
the Fron Board, close to the OSCILLATOR front switcher.
P12 regulates the frequency, while P1 regulates the level. Factory preset is 1 kHz, 0 dBm.