User manual

TELEPHONE HYBRID REMOTER DETAIL
| TELEPHONE HYBRID REMOTER DETAIL
35
14 TELEPHONE HYBRID REMOTER DETAIL
14.1 PHONEX D1 CONTROL SOFTWARE DESCRIPTION
The PhoneX D1 control software (Telephone Hybrid Remoter) is basically divided into 4 parts:
1. Hybrid 1 section
2. Levels section
3. GPI / GPO status section
4. Setup & Disconnect section
14.2 HYBRID 1 SECTION
The “Hybrid 1 Section” features a series of operating and monitoring controls relating
to the first telephone hybrid connected to a PSTN/POTS line.
The monitoring part concerns the Receive and Send levels and shows whether
PhoneX is in Ducking and Limiting operating mode; it also shows the line status, ring,
echo canceller and if the denoiser is active.
As regards device operation, the controls available are:
ON HOOK – ATTEN – HOLD – DIAL
ON HOOK: in this status PhoneX can hook an incoming call or open the telephone line. Upon receipt
of a call the LED of the incoming call flashes and the PhoneX Remoter displays the RINGING Line
Status for the hybrid with the incoming call. The relevant RING LED lights up in the GPO Status and
Line Status sections. The relevant relay of the Opto Interface Hybrid communication port closes. See
the appendix at the end of this manual for the pinout and connections.
To end a call press OFF HOOK.