Specifications

SETTINGS
Pag. 14
SETTINGS
5.13 BUZZER DISABLING
Internal buzzer (signalling an incoming call) is factory preset enabled. It may be disabled through the
corresponding jumper (J 11, close to it).
5.14 INPUT IMPEDANCE
At the delivery, ‘Send’ and Meeting input Impedances are set at 10 Kohm. The impedance may be set to 600
Ohm by moving the jumpers located on the mother board (J10) and on the Meeting board (J4 and J5).
5.15 MEETING OUTPUT LEVEL
At the delivery it is set to 0 dBm. It can be adjusted in the – 6 dBm – 6 dBm range by means of the trimmer
P3 and P4 next to Jumper J 7 and J9 after moving these jumpers to Variable position.
CAUTION: Before moving any jumper setting, please switch off the equipment and disconnect it
from the Main