User manual

‘LCD’ VERSION - FRONT PANEL OPERATION ENG
Page 45
21.3 HOW TO CHANGE THE CURRENT AUDIO PRESET CURVE
Starting from the default screens (showing In/Out levels),
1) press the Jog Wheel once. The Block Diagram will appear, with the INPUT SELECT block in
evidence
2) using <right> arrow and then the <down> arrow, highlight the PRESETS block:
3) Press the Jog Wheel: the CHANGE PRESET screen will appear.
That screen informs about the curve currently On Air and prompts an alternative one (called ‘PRESET’).
By rotating the Jog Wheel, scroll the Curve list until the desired one is shown on the screen.
At this time,
- selecting LOAD the new curve will be put on air and the CHANGE PRESET screen will not
close, thus allowing a new curve selection.
- selecting OK the new curve will be put on air and the CHANGE PRESET screen will close.