User manual

ENG COMMUNICATION PORTS AND GPI/O WIRING
Page 34
19.3 USB PORTS
USB
The processor features two standard USB – B Type USB 2.0 ports (one located
on the Front Panel and one on the Rear Panel). Connect the USB-B connector of
the computer’s USB cable to the appropriate USB port on the Falcon 50 unit and
connect the other end to an available USB-A port on your computer.
The USB connection can be operated ONLY with proper drivers
installed on Yr Pc. Refer to the next Paragraph for USB driver
installation.
If you connect The Falcon 50 to a computer via USB port, do NOT
disconnect the USB cable while is being accessed by a computer.
If you do, you may corrupt the data on the processor memories.
The two ports run independently, so that You may keep connected two
pcs at the same time, even if only one of them at a time will give control
over the processor.
19.4 INSTALLING USB DRIVERS
Plug your Falcon 50 USB cable to your PC's USB port.
The following message may appear on your PC's Taskbar:
The New Hardware Found Wizard should appear: