User manual

ENG FRONT PANEL DESCRIPTION
Page 26
16.2 LCD VERSION
The Falcon50 front panel consists of a pair of Liquid Crystal Display (LCD), six push buttons and a large
knob. The LCDs are 240 x 128 pixel displays. The buttons and the knobs are used to browse the Falcon 50
menu and to configure it. USB socket and Phone jack socket are also fitted on the front panel.
<Left Arrow> , <Right Arrow>, <Up Arrow>, <Down Arrow>. They are used to
browse between blocks or between lines inside each block.
<Phones> this key recall the Headphones volume control, shown on the Left LCD
screen.
<Esc>: This key selects the previous screen in a sequence of screens. When you
use this key to exit a configuration screen, any configuration parameters that were
modified will return to their original values.
JOG WHEEL
Whenever pressed, it enters the configuration menu. Pressing this wheel has the same result
as pressing ENTER key on the software. Whenever rotated, it allows to scroll the menu and
modify the parameters.
Connection ports:
HEADPHONE
SOCKET
Any channel pair that is going through the processor can also be routed to the
headphone jack on the front panel using the MONITOR selector switch in the
software. Headphone volume is controlled by pushing the associated button (see
4) on the front panel: a specific level menu will be displayed on the Left LCD
display screen (1).
USB PORT B Type port, designed for the easiest connection to the processor.
Special drivers are needed to be installe don the pc for proper connection. Refer to
the Chapter ‘COMMUNICATION PORTS AND GPI/O WIRING’