Specifications

RDS SETTINGS (MPX Version only) FALCON 15 - ENG
Page 50
10 RDS SETTINGS (MPX Version only)
10.1
INTRODUCTION
The processor includes, as an option, a complete RDS encoder, programmable by a PC connected to its Serial
Ports.
The RDS section controls (for RDS messages and other services) are accessible only via the remote control
software supplied with your processor. Please refer to the previous chapter for installation & setup procedure
instructions for this software.
10.2 RDS SETTINGS PANEL
This panel allows the operator to adjust RDS Signal Level and to switch on/off RDS generation.
10.3 MAIN PANEL
Access the RDS section by clicking the ‘MAIN’ button on the right: This will open the main screen, where you
can set the main parameters of the RDS service.
Once you have finished loading one or more fields, click Send to enable one or more parameter changes or click
Cancel to quit without save the changes.