Specifications

ST-OUT VERSION DESCRIPTION FALCON 15 - ENG
Page 30
5.5 SERIAL PORTS
Falcon 15 features up to four optoinsulated RS232 serial ports (port 3 and 4 are available
as an option) which allow the remote control and RDS programming both through local -
or remote PCs, UECP programmer, etc.
In particular, these connectors are for a local bidirectional computer connection when the
BSN - Remote Control software is loaded onto a local computer. Connect a standard
serial cable (not crossed) between the RS-232 connector and a serial port connector on
the computer. Cable length must not exceed 10 mt.
The ports can be separately enabled / disabled via the menu. UECP protocol allows the
user to assign different properties, data speed, acces to commands, etc to every port (see
§ 4.5.1).
The four serial ports support Tx and Rx signals only. One serial cable comes with the unit.
5.6 ANALOG AUDIO OUTPUT (Male XLR)
Balanced XLR-type connectors are used for output analog audio.
The stereo analog outputs are designed for standard 0 dBu (line- level) balanced signals.
Output level setting is done using the software parameter settings (see § 6.2).
XLR pinout:
Pin 1 Gnd
Pin 2 Signal
Pin 3 Return
In case of unbalanced connections, please connect the cold pole (Pin 3) to the ground
(Pin 1).
The impedance is set to 600 (electronically balanced).