Specifications

IN & OUT SETTINGS (MPX VERSION) FALCON 15 - ENG
Page 24
4.3 HOW TO CONFIGURE THE RDS OUTPUT (RDS MODULE SETUP)
The processor generated RDS signal** can be adjusted by means of the RDS Module Setup menu.
A RDS Encoder menu allows You to turn the encoder On and Off.
The RDS signal Level may be adjusted within the deviation range. Here below are presented some relations
between deviation and RDS signal level:
-37.5 dB D=1.0 KHz
-31.5 dB D=2.0 KHz
-28 dB D=3.0 KHz
-25.5 dB D=4.0 KHz
-23.5 dB D=5.0 KHz
-21.9 dB D=6.0 KHz
- The default
operating level is -31.5 dB, D = 2.0 KHz with an overall MPX level of 0 dBm
- The RDS signal is available on the MPX Out connector, blended together with the MPX signal.
Also see Section 4.2.3 for setting the overall MPX signal
The RDS On Split option allow / don’t allow the Falcon 15’s RDS signal to be output in MPX splitted session.
** Falcon 15 with RDS option installed – Ref to Chapter 1.1