User`s manual

Appendix
TCP/IP AX3000 User's Manual 217
A.10.6 - The 'IP Addr. Set by Ping' Parameter
This parameter is common to all TCP/IP AX3000 models.
This parameter allows or disables the AX3000 IP Address to be set by a ping
command. (see Appendix A.7).
Note: a new value takes immediately effect.
A.10.7 - The 'Rejection Threshold' Parameter
This parameter is for AX3000 models 55/55E, 60/60E and 65/65E.
Changing the value of this parameter (high → low) increases the AX3000
reception sensitivity. This allows the AX3000 to try to accept weak network
signals (due to low quality wire, excessive length, etc).
In the event of erratic disconnections, this parameter can be modified (if too
many incorrect frames are received, disconnections may occur). It is
recommended that this parameter is modified with caution, as the more
sensitive the AX3000 is to data reception, the more sensitive it is to external
interference. It is recommended to check cable.
Note: changing this parameter takes effect at the next AX3000 boot time.
A.10.8 - The 'Scan Frequency (800x600)' Parameter
This parameter is for AX3000 models 60/60E and 65/65E.
This parameter allows the 800x600 VGA monitor frequency to be changed. (For
1024x768 the resolution is always 60 Hz.) Two frequencies are available: 60 Hz
or 72 Hz.
By default, the frequency is 72 Hz. If this is not supported by the VGA monitor,
set it to 60 Hz.
Note: the frequency modification takes immediately effect.
A.10.9 - The 'AUX1/AUX2 Frequency Tuning' Parameter
This parameter is for AX3000 models 55/55E, 60/60E and 65/65E.
The base frequency (Baud rate) used for the transmission in all serial devices,
(9600 bits per second, for instance) is set by a quartz crystal. If the reference
frequency of the quartz crystal is incorrect the base frequency may differ from