User`s manual

Appendix
196 TCP/IP AX3000 User's Manual
In the following parameter lists, the possible values are bracketed after each
set-up parameter.
A configuration file can either be created using a text editor, or obtained from an
already configured TCP/IP AX3000 (by using setup_get remote command).
When a configuration file is obtained from an AX3000, the inactive parameters
(undefined hosts, print server unused, colouring mode disabled, etc) are
commented out.
The sample configuration file, shown In the following pages, is typical of a file
obtained from an already configured AX3000. Notes and headings have been
inserted for clarification and would not appear in the file.
Header
BEGIN_AX_SETUP V1.1
#########################################################
# TCP/IP AX3000 Platine Terminal #
# #
# Ethernet address: 00:A0:34:00:27:10 #
# Firmware: FK5.BV2.1a/TCP.FR.0303a.STD #
#########################################################
#
# RESET_CMOS
Note: the RESET_CMOS command allows all the set-up parameters (except the
AX3000 IP address) to be reset. When the configuration file is obtained from an
AX3000, this RESET_CMOS command is displayed as a comment.
Ethernet Parameters
ethernet_dhcp_used=no (yes | no)
ethernet_dhcp_axname (character string, 64 char max.)
#ethernet_ipaddr=192.168.1.241 (address IP format)
#ethernet_netmask=255.255.255.0 (address IP format)
ethernet_dhcp_netmask (yes | no)
ethernet_dhcp_defrouter (yes | no)
ethernet_dhcp_DNSserver (yes | no)
ethernet_dhcp_srchdomain (yes | no)