User`s manual

Remote Set-Up
TCP/IP AX3000 User's Manual 159
ERR 202: xxx: invalid value.
Command: setup_send
Cause: the value assigned to this set-up parameter (xxx) is not
valid (example: multi_nbpage=10).
Consequence: the set-up parameter is ignored. The current value of this
parameter is retained.
Solution: check the possible values of this parameter (Appendix A.6).
ERR 203: xxx: no place to store udk value.
Command: setup_send
Cause: not enough memory to store the udk_xxx parameter (udk
stands for User-Defined Key; a function key for example).
Consequence: the default value of this udk parameter is restored.
ERR 204: line(s) after the trailer label ignored.
Command: setup_send
Cause: END_AX_SETUP is not the last line of the file.
Consequence: the lines after the trailer label are ignored. The AX3000 set-
up is updated.
Solution: delete these lines.
ERR 211: service name/number error. Service(s) may be reset.
Command: setup_send
Cause: Other services, such as print or tty, use the same identifier
(TCP port or name).
Consequence: to get a consistent configuration, some services have been
removed.
Solution: check service identifier values.
ERR 212: host error. Host(s) may be reset.
Command: setup_send
Cause: host parameters are missing or two host names are
identical.
Consequence: to get a consistent configuration, some hosts may have been
removed.