User`s manual

Remote Set-Up
158 TCP/IP AX3000 User's Manual
ERR 106: cmos busy.
Command: setup_send
Cause: another command (setup_get or setup_send) is running, or
another user has entered set-up on the target AX3000.
Consequence: no effect.
Solution: Either wait for a few seconds and repeat the command, or
arrange for the other user to exit set-up on the target
AX3000.
ERR 113: password required
Command: setup_send, ax_reboot and ax_download
Cause: the AX3000 Interactive Set-Up is password-protected. This
password hasn't be specified within the command.
Consequence: no effect.
Solution: use the right password.
ERR 114: invalid password
Command: setup_send, ax_reboot and ax_download
Cause: the AX3000 Interactive Set-Up is password-protected. This
right password hasn't be specified within the command.
Consequence: no effect.
Solution: use the right password.
10.4.2 - Warning Error Messages
Warning error messages do not stop the command but indicate a problem (such
as a syntax error). The following warnings may occur:
ERR 201: xxx: unknown parameter name.
Command: setup_send
Cause: the set-up parameter (xxx) is unknown.
(e.g.: s1_screencolumn instead of s1_screen_column).
Consequence: the set-up parameter is ignored. The current value of this
parameter is retained.
Solution: check the spelling of the set-up parameter (Appendix A.6).