User`s manual

Installing under OS/400
TCP/IP AX3000 User's Manual 109
b) Under OS/400
The whole AX3000 set-up can be obtained by invoking the following command:
===> RUNRMTCMD CMD(SETUP_GET) RMTLOCNAME('192.168.1.241' *IP)
or a partial set-up can also be obtained (only used set-up parameters are sent):
===> RUNRMTCMD CMD(SETUP_GET_LITE) RMTLOCNAME('192.168.1.241' *IP)
Where:
- SETUP_GET : command for getting the whole set-up,
- SETUP_GET_LITE : command for getting the partial set-up,
- 192.168.1.241 : AX3000 IP address.
For more information about these commands, refer to Chapter 10.
6.4.4 - Setting-Up the AX3000
No OS/400 command allows the contents of a set-up file to be sent over the
network. The following example describes the use of rsh Windows command:
c:\> rsh 192.168.1.241 setup_send password < /tmp/axel
Where:
- 192.168.1.241 : AX3000 IP address,
- setup_send : command for set-up the AX3000,
- password : specify the set-up password if set.
For more information about this command, refer to Chapter 10.
6.4.5 - Downloading a Firmware
To download an AX3000 firmware through TFTP:
===> RUNRMTCMD CMD('AX_DOWNLOAD password /axfirm/ax3000 192.168.1.180')
RMTLOCNAME('192.168.1.241' *IP)
To download an AX3000 firmware through BOOTP and TFTP:
===> RUNRMTCMD CMD('AX_DOWNLOAD password /axfirm/ax3000 192.168.1.180')