User`s manual

Installing under OS/400

TCP/IP AX3000 User's Manual 97

- AUX2 port: select [Configuration]→[Terminal]→[General]. Within this

box, if 'Mouse' parameter exists set it to 'AUX2'. Then, select

[Configuration]→[Ports aux.]→[AUX2]. Within this box, set "Associated

Service" to "none" and "Operating Mode" to "Mouse".

The mouse must be enabled for each session. This is done though the session

profile ([Configuration]→[Terminal]→[Session X]). Within this box, select

"General Parameters" and press <Space>. Within this box, set "Mouse

Enabled" to "Yes". See Chapter 6.1.3.

The mouse will be available after rebooting.

6.2 - USING THE AX3000

6.2.1 - The 5250 Status Line

Note: the 5250 status line is different than the AX3000 TCP/IP status line. (The

AX3000 TCP/IP status line displays information about current connected

sessions. This line can be enabled/disabled through the AX3000 Set-Up).

The 5250 status line is displayed at the bottom of the screen and gives the

following information:

System Available Upper Shift

Message(s) Waiting Caps Lock Function key Assignment

Input Inhibit Insert

Available Keystrokes Cursor

Mode: R (Record) Locator

P (Process)

Diacritic Mode