User`s guide

Remote Administration
________________________________________________________________
94 TCP/IP AXEL Platine Terminal
Consequence: the Set-Up obtained by the command is invalid (the trailer
label is missing).
Solution: run the
rcmd
command again.
ERR 105: invalid rcmd command.
Command:
setup_send
,
setup_get
or
ax_reboot
Cause: the rcmd keyword is unknown.
Consequence: no effect.
Solution: use
setup_send
,
setup_get
or
ax_reboot
.
ERR 106: cmos busy.
Command:
setup_send
Cause: another
rcmd
command (
setup_get
or
setup_send
) is
running, or another user has entered Set-Up, on the target
AX3000.
Consequence: no effect.
Solution: Either wait for a few seconds and repeat the command, or
arrange to exit Set-Up on the target AX3000.
10.4.2 - Warning Error Messages
Warning error messagess do not stop the
rcmd
command but indicate a
problem (Such as a syntax error, for example). The following warnings may
occur:
ERR 201: xxx: unknown parameter name.
Command:
setup_send
Cause: this Set-Up parameter (
xxx)
is unknown.
(eg:
s1_screencolumn
instead of
s1_screen_column
).
Consequence: the Set-Up parameter is ignored. The current value of this
parameter is retained.
Solution: check the syntax of the Set-Up parameter (section 10.5).
ERR 202: xxx: invalid value.
Command:
setup_send
Cause: the value given to this Set-Up parameter (
xxx)
is not valid
(example:
multi_nbpage=10
).