User`s guide

Remote Administration
________________________________________________________________
TCP/IP AXEL Platine Terminal 93
10.4.1 - Fatal Errors
Fatal errors stop the
rcmd
command. The following fatal errors may occur:
ERR 101: header label expected.
Command:
setup_send
Cause: the AXEL header label (
BEGIN_AX_SETUP
) is not the first
line of the configuration file.
Consequence: the
rcmd
command is aborted, the AX3000 Set-Up is not
modified.
Solution: check the file. Replace it with a correct AXEL configuration
file.
ERR 102: bad header label protocol version.
Command:
setup_send
Cause: the protocol version (included in the header label) cannot be
processed by the current AX3000 firmware.
Consequence: the
rcmd
command is aborted, the AX3000 Set-Up is not
modified.
Solution: use a configuration file with a compatible protocol.
ERR 103: trailer label not found. Default factory set-up reloaded
Command:
setup_send
Cause: the trailer label (
END_AX_SETUP
) is not found (either this
label is not included in the configuration file or the
rcmd
connection failed).
Consequence: the default factory Set-Up is reloaded (to replace the
inconsistent configuration caused by the missing trailer
label).
Solution: add this label to the end of file and run the
rcmd
command
again.
ERR 104: Can not get complete set-up (rcmd command aborted).
Command:
setup_get
Cause: a network problem has occurred or the
rcmd
command has
been killed or aborted.