User`s guide

Remote Administration
________________________________________________________________
92 TCP/IP AXEL Platine Terminal
The message '
Reboot in progress...
' is then displayed on the operator
console, the AX3000 is reset and the new Set-Up is implemented. If a
connection problem occurs, a time-out error message is displayed.
10.3 - OBTAINING A CONFIGURATION
To obtain an AX3000 configuration, use the
rcmd
command together with the
setup_get
keyword. This command sends a list of all AX3000 parameters to
standard output, which may be redirected to a file:
# rcmd ax_name setup_get > /tmp/fic <CR>
The message '
Load set-up in progress...
' is displayed on the operator
console when the
rcmd
command is processing. If a connection problem
occurs a time-out error message is displayed.
When the Set-Up parameters are loaded, the message '
OK, set-up sent
'
is displayed on the operator console. If other messages are displayed, refer to
Section 10.4.
The configuration file lists each Set-Up parameter. Refer to Section 10.5 for a
detailed description of this file.
10.4 - ERROR MESSAGES
This chapter explains the error messages which may appear (displayed on
'standard error') during operation of the
rcmd
command.
Two error groups are distinguished:
- fatal errors: numbered from 100 to 106
- warning errors: numbered from 200 to 213